Saturday, December 20, 2008

Catching Up: Rust Orange Shirtdress











This past summer I worked on a shirtdress project that was originally inspired by a dress worn by June Cleaver (Barbara Billingsley) in the vintage television show, Leave it to Beaver. It was full skirted, had bais-cut sleeves, and - the feature that attracted me the most - a pair of hip pockets with overturned flaps.

I started out by searching for a pattern to use so that I could make something like it, and this is what I found:



It wasn't a "carbon copy" of June's dress, but it was close enough to where I could use it as a base to be adapted to the design I liked.

The original dress was made of a printed material with small motifs arranged in a striped pattern. Since I couldn't really find anything close enough, I decided to try using a Rust Orange Shirting from Fashion Fabrics Club that features a subtle, tone-on-tone stripe.



Materials:
-Striped shirting fabric
-Batiste (for interfacing)
-7/8" wide Grosgrain ribbon (for waistline stay)
-Buttons (photo below)

Pattern Alterations:
First of all, I had to resize the pattern. It was a size or two larger than my measurements, so I graded it down using these instructions from Sensibility.com.

I also made a few fitting changes for my figure, which included taking extra room out of the bodice (SBA), making a short-waist adjustment, and adjusting the darts in the back of the bodice. I had to play around with the back and waistline darts a bit; I even had to take them in a little again - along with the side seams - when the dress was nearly complete.

To conform the pattern to June's dress design, I flared all of the skirt pattern pieces to be wider at the hem. I turned the sleeves and cuffs on the bias, too. In the original dress, it looked like there was a seam down the center of the sleeve, creating a chevron pattern with the bias-cut grain, but my fabric was a little too thick to make this feature work smoothly, so I cut each sleeve in one piece, instead. For the pockets, I needed to incorporate the pocket pattern pieces into the side/front pieces of the skirt, rather than attaching them as patch pockets. This caused me to split the side/front skirt piece in two - a top piece which meets the bodice at the waistline (and part of which is also the inside of the pocket) and a bottom piece (which makes up the rest of the skirt portion). I also made the pocket pieces to buckle slightly outward, so that they would stand out a little.

Construction:
For the most part, the construction was fairly simple - basically assembling the bodice and the skirt, then seaming the two together and working on the collar and button placket. I followed the instructions rather loosely, but I did use a sew-in interfacing, as directed. I didn't receive very positive results when I tried fusing the fabric with interfacing, so I used batiste by basting it to the wrong side of the areas that needed interfacing.

Originally, the collar/under collar pattern was supposed to be cut all in one piece, with a fold along the outer edge, but I made a separate under collar piece. This allowed me to make the under collar piece an 1/8" smaller around the outside edges so that the seams would pull slightly toward the underside of the collar, where they won't be seen. While I was at it, I decided to cut the under collar in two pieces on the bias, with a seam down the center.

(This picture is probably the most accurate in representing the actual color of the dress.)

I also stitched a waistline stay to the seam allowance of the waistline to help support the weight of the full skirt:



Last but not least, a better view of the buttons. They're not very easy to photograph because they're somewhat glittery and glow when I use the camera's flash. They're not quite as dark as they look below, but this is the best shot I could get ;-)

8 comments:

Shannon said...

Gorgeous dress - June Cleaver would be green with envy!

Kristy Chan said...

your dress is so fabulous - all the effort and time you put into it really shows in the quality of the finish. Where do you plan to wear this?

wendy said...

Oooh- fantastic! I really love the full skirt and the sleeve cuffs. :-)

Rebekah said...

Thank you, everyone, for the kind comments! I really enjoyed working on this project!

Kristy - I actually wore it to church, one time! It was back in late September or early October when the leaves were changing colors, and we stopped by the cider mill on the way home. I think it's definitely great for fall :-)

Anna said...

I love it! And I wish I could wear that color... it's gorgeous.

~Anna

Julia said...

I love that dress! I love orange! Your style is wonderful!! I'll be following your blog. Julia

YayaOrchid said...

Such a beautiful dress! I love it!

I've passed an award on to you. Won't you visit my blog for details?

Allison said...

that dress is fantastic, what an amazing seamstress you are! great inspiration to keep going until I learn more skills. :-) keep posting!love your work!


Allison.