Monday, December 12, 2011

Herringbone Coat: Padstitching the Collar/Lapels

Now that the stand of the collar is all filled in with padstitching, the "fall" of the collar, or the area that drapes down from the roll line at the back of the neck, can be padstitched as well. This design is a little unusual because the lapels are included as an extension of the collar. I had to do a bit of guesswork and try to adapt the instructions from my tailoring books as best I could, since this collar differs so much from all the examples I could find.

Before padstitching the entire collar, I went ahead and attached it to the coat. This is probably a bit unconventional, but I did it because I wanted to tape the roll line before padstitching the lapels, and the roll line extends from the collar into the front jacket piece. Some directions that I've seen show padstitching before taping, but since I wanted to ease the lapel to the length of tape, I thought taping the roll line first might be a better route for me (the second photo shows where the roll line is taped, from the shoulder seam to the break point).


The rows of padstitching run parallel to the roll line. In each corner of the lapels, shorter stitches are taken while the point is rolled tightly, so that the finished lapels will curl toward the jacket body.


After the padstitching was complete, I trimmed away the seam allowances and taped the edges to prevent them from stretching out of shape. I wasn't able to get the recommended plain-weave tape for this project but used twill tape instead. I used a fell stitch to secure it in place and found that it worked better than catch-stitching on the twill weave.  

The white towel under the lapel on the right has been
 dampened to help set the shape as the roll line is steamed.

Having the collar on the jacket body made it a little awkward to steam the lapels, but Erika of Swingin' It In Vintage wrote a post about tailoring a cut-on shawl collar that I found very helpful. My collar is seamed to the jacket rather than being cut-on, but I followed the same idea of using towels to protect the body of the jacket from excess steam, while steaming one lapel at a time (thank you so much for sharing this, Erika!). 


Now it needs the upper collar and the lower coat portion to be attached!

2 comments:

Erika said...

Thank you so much for your lovely comment on my blog! I'm so happy you found my little "tutorial" useful =)

I love the fabric you've chosen for you coat, and the pattern looks very promising as well. Makes me want to do a herringbone coat as well... Hmm, maybe not right now though... =) You've done such an amazing job, I'm looking forward to seeing the finished coat!

Rebekah said...

Thanks, Erika!