Friday, January 06, 2012

Herringbone Coat: Upper Collar and Front Facing

At the time of my last post, I was working on the seams of the lower coat, which included in-seam pockets. The lower center front panels coat also needed to be interfaced, but since they didn't need as much shaping as bodice, I decided to interface these panels with muslin rather than hair canvas. As the pictures show, my progress has jumped ahead quite a bit; the skirt portion of the coat has been seamed to the bodice, and the upper collar and facing have been attached, too.

Since the wool that I used for this coat is the same weight as recommended by the patten, I didn't need to adjust the under collar for the "turn-of-cloth," as I found it had already been accounted for.

Though none of these photos show it, I modified the back lining pattern to include a back neck facing. This way, the facing from the front continues around to the back of the coat (this was not absolutely necessary; it was simply a detail I preferred).  

Once the upper collar and facing were seamed to the coat, I followed the tailoring instructions in the RD Complete Guide to Sewing to trim, grade, clip and press the seam of the collar and center front. They're very detailed and I always find them helpful when dealing with is step in my jackets or coats. After this, I rolled the seam toward the under collar and used tailor-basting (the diagonal white stitches in the photo) to hold it in place for hand-understitching and more steaming.

With the facing covering the inside of the coat front, openings needed to be made in order to access the wrong side of the bound buttonholes. Usually this can be done by simply cutting a slit the length of the buttonhole, turning under the raw edge, and slip-stitching it to the back of the buttonhole, but since my fabric tends to fray, I opted for a different technique called the "windowpane" method. This involves using a patch of facing to make a little window where the front facing meets the buttonhole.


 I used silk organza for the facing patches because it's strong and presses crisp at the edges. 


On the right side of the facing, it yields a neat little window that will be slip-stitched in place around the back of the bound buttonhole.


No comments: