For the most part, I've been using the instructions from Tailoring: The Classic Guide to Sewing the Perfect Jacket , along with the tailoring section from the Reader's Digest (RD) sewing guide, to make patterns for and apply the hair canvas interfacing. To draft the bust dart that comes out from the armhole, however, I used the information from Marji's posts on the The Great Coat Sew Along, which can be found here and here (there is just a wealth of helpful information on this site! Thank you, Marji, for sharing this technique!).
The picture above shows the "shield" piece that supports the area between the shoulder and bust to help prevent it from drooping toward the body. After completing the bust dart and basting the shield in place, I aligned the markings on the canvas with the details of the bodice front and tailor-basted it in place.
I don't have any pictures of the bodice back right now, but also I followed the instructions in the Tailoring book for interfacing the back with a muslin stay and taping the shoulder seams when attaching it to the bodice front.
Before adding the collar, I trimmed away the seam allowance of the interfacing at the neck edge and catchstitched the canvas in place. The interfacing seam allowances on the neck edges of both jacket and collar are not trimmed away in the Tailoring book, but in the RD sewing book they are. I needed to reduce the bulk somewhere to avoid having two layers of hair canvas going into this seam, so I decided to trim it on the bodice, but include it on the collar.
Now for padstitching the collar! It's visible in the picture where it's starting to "roll" now that I've filled in the stand.




2 comments:
I'm loving your instructions - am making for my daughter and have never made something so tailored before. You refer to a 'shoulder shield'. Is this just an extra layer of the canvas? Can I cut it roughly to the shape shown in the picture and put it over the top of the front fabric/interfacing?
Hi Mabe,
I'm so glad you found this post helpful! Yes, the shoulder shield is a second layer of the same canvas. I used the instructions for cutting interfacing in the Tailoring book. It basically has you follow the shape of the armhole and shoulder seams, cutting the piece 1/8-inch inside the seamlines to reduce bulk. The inside of the shield should stop 1/2-inch from the roll line and run parallel to it at the front, and the length of the piece should be about two-thirds the length of the armhole.
In the case of the interfacing piece that I cut for my coat, the inside edge could not run parallel to the roll-line, since the roll line was running through the collar piece. The solution for this pattern seemed to be to bring the shield piece right up to the collar seam.
The book I mentioned above was super helpful for me when I made this coat, so if you can manage to find a copy, I highly recommend it!
Hope this helps :-)
-Rebekah
Post a Comment